Does not fill
Check that the accessible supply tap is open and report any inlet error. A restricted supply, inlet valve or water-level system may need testing.
Top-loader service across Durban
Our team repairs conventional and modern electronic top loaders that will not fill, agitate, drain or spin, as well as machines that shake, leak or stop during a programme.

Repair booking request
Share the fault, model and service address. We'll check the details and confirm the next available appointment with you.
A top loader relies on a connected sequence of water-level sensing, filling, agitation or pulsation, drainage, lid safety and high-speed spin. We identify the point at which your machine fails instead of selecting a part from the symptom alone.
Testing may cover the inlet valves, pressure or level system, lid switch or lock, agitator or pulsator, coupling, belt, clutch, gearbox, motor, capacitor, suspension, drain pump, harness and control system. The relevant checks depend on the model and condition.
We inspect the installation and load behaviour as well as internal suspension and drive conditions. A machine that moves violently should not be held down or repeatedly restarted because it can damage hoses, wiring, the cabinet and surrounding property.
We explain the diagnosed fault, proposed replacement part and labour before additional work proceeds. Completion depends on the fault and part availability; ask the team to confirm any applicable written guarantee terms.
Check that the accessible supply tap is open and report any inlet error. A restricted supply, inlet valve or water-level system may need testing.
The wash mechanism varies by model. A lid safety condition, agitator or pulsator drive, motor or control issue can prevent movement.
Drainage and lid conditions can prevent spin. We confirm the failed stage before deciding whether a pump, drive or control repair is needed.
Uneven loading, unsuitable installation or suspension wear can cause severe movement. Stop the cycle if the machine strikes nearby surfaces.
Tell us whether the machine has an agitator or pulsator, whether it completes the drain stage, if the lid locks, and which cycle is affected. Include the full model label to assist parts identification.